Model No:TP-312VB
Details:
Important:
This is a vibration-activated sensor that triggers an alarm when an intruder turns the doorknob or pushes the door. The sensor detects vibrations caused by contact with the door, activating the alarm.
Some intruders may try to open the door very slowly and gently, creating only minimal vibrations. To maximize sensitivity, ensure the hanging strap is securely fastened to the doorknob during installation. Pay attention to the position of the alarm relative to the door, adjusting it to allow for greater movement and better detection of even the slightest actions.
Instructions:
- Power supply for host: 1 unit 9V battery (not included, recommend brand alkaline battery)- Power supply for remote controller: 1 unit 23A 12V alkaline battery (included)
- Battery install for host:
How to use?
-Install 1 unit 9V battery for host
-Turn on the switch of host
- 
Alarm mode: press 1 time of the arm button on remote controller, host ready for detect vibration, after triggered by vibration, host will have 20 seconds sound alarm, then stop and ready for next detection
- 
Disarm mode: press 1 time of the disarm button on remote controller, the hoststop alarming immediately
- 
SOS mode: press 1 time of the SOSbutton on remote controller, the host will have 20 seconds sound alarm
- 
Doorbell mode: press 1 time doorbell button of remote controller, host ready for detect vibration, after triggered by vibration, host will with 3 times of “dingdong”, then stop and ready for next detection
Volume adjustment:
1, Disarm the host by remote controller
2, Press and hold disarm button, host will with “di”, “di di”, ”di di di”,
if you need highest volume, please release the disarm button when you hear “di”,
if you need middle volume, please release the disarm button when you hear “di di”,
if you need lowest volume, please release the disarm button when you hear ”di di di”.
Sensitivity adjustment:
1, Disarm the host by remote controller
2, Press and hold doorbell button, host will with “di”, “di di”, ”di di di”, ”di di di di”, ”di di di di di”,
if you need highest sensitivity, please release the doorbell button when you hear “di”,
......
if you need lowest sensitivity, please release the doorbell button when you hear ”di di di di di”.
Add remote controllers to host (extra controllers not included):
1, Switch off the host
2, Press and hold doorbell button
3, Switch on the host, the light of host will turn on
4, Press the disarm button fast, host with “di di”, remote controller add successfully
How to install the host?
1, Hang on the door handle by the included lanyard: put the lanyard close to the door most, tighten the elastic clasp to door handle, make sure the host close / touch the door, the host will work better
No.2: Elastic clasp isocking door handle
No.3: Make sure the host is close to thedoor
2, Sticker on the window / door or safe by included double side sticker
3, Attach to a metal door or safe by the magnet of host
4, Fix by cable ties (not included)
Notice:
1, The host not waterproof, if use outdoor need pack it well
2, Don’t lose the remote controller
3, Pull out the antenna of remote controller will with longer control distance
4, If long time don’t use, suggest to switch off the host and pack them well
